It is currently 2020-09-22 2:30


Network folders and Auto-Support

Discussions about SolidPreform and other printing software.
  • Author
  • Message
Offline

Flashhawk

  • Posts: 2
  • Joined: 2020-08-21 9:24

Network folders and Auto-Support

Post2020-08-21 9:32

Hey,
could you please implement the ability to see and load from Network folders? I got everything on a NAS and i don't even understand why you have kept this out...
And at least in V3.3.1 auto-support generation is a little underwhelming. I tried to support a Miniature with a staff and the algorithm did not find it necessary to support the end of the staff which would be floating in mid air... I mean sure, manual support editing is always necessary, but to that extend?
Please comment or better: fix it.
Thank you
Flashhawk

Return to Software

Who is online

Users browsing this forum: No registered users and 1 guest

cron